Customer 1006

Mechanical / Tire Shop, Saskatoon

Questions?

Customer was installing auto hoists and needed to know where his in-floor heat lines ran so the installers could avoid them. We had only a 1" tolerance for error.

Hoists were installed without striking any in-floor heating lines.

Base of hoist had to straddle lines with securing bolts driven into clear concrete

A short window of opportunity is available to discern between lines and cooler concrete

When conditions are right, lines show up clearly

Notice the difference in temperature between lines & concrete is only 2 degrees

One hole in the wrong place = One unhappy customer

Infrared thermography shows heat reflections of installers on flloor

Lines were marketed with chalk and then checked and rechecked (and checked again...)

Comments?

Copyright Thermal Optics 2009 All Rights Reserved